Infinite Irons Rolled Rear Shader Spring 0.018" Thick x 1.281" Long

Adding to cart...
RRS-S18.jpg RRS-S18.jpg
SKU: RRS-S18
Availability: In Stock
Infinite Irons Rolled Rear Shader Spring (.018 X 1.281 Long)
$3.00
Adding to cart...
Added to your Favorites.
Infinite Irons Rolled Rear Shader Spring (.018 X 1.281 Long) - These Are The Rear Springs That Joey D. Uses On His Machines That Have Been Sized To Fit His Liners And Shaders. The Spring Length Is 1 9/32 Inches Long Overall And 1 23/32 Inch From The A-Bar Screw Hole Center To The Slot Where An 8-32 Screw Will Fit. It Is Also Slotted At The Rear To Allow For A Longer Distance Between Screws. The Spring Width Is 1/2 Inch Wide. Please Measure Carefully To Figure The Fit Of Your Springs. This Spring Is Commonly Used On The Following Machines: The Saros Shader, The Gearhead Shader, The Eris Shader, The Tattooer Shader And The Keyhole Shader. Measure Carefully.

SHARE ITEM: