Infinite Irons Rolled Front Spring E 0.020" Thick x 1.490" Long

Adding to cart...
RFS-E20.jpg RFS-E20.jpg
SKU: RFS-E20
Availability: In Stock
Infinite Irons Rolled Front Spring E (.020 Thick X 1.490 Long)
$3.00
Adding to cart...
Added to your Favorites.
Infinite Irons Rolled Front Spring - E (.020" Thick X 1.490 Long) - The Center Of The Hole Is .220" From The Rear. The Spring Is Rolled And Ready To Go On Your Machine. Install The Front Spring, Push It Down To Your A-Bar And The Angle Is Set, Adjust The Tension In Your Rear Spring And You'Re Done. The Length Of This Spring Is Specifically Made For A Shader And Helps Your Machine Run Smoother And Stay In Tune Longer. A Good Way To Get The Length You Need Is To Install Your Rear Spring And Put Your Contact Where You Want It. Measure From The Center Of The Screw To The Front Side Of The Contact Screw And Add .220 To The Measurement. This Spring Is Commonly Used On The Following Machines: The Saros Shader, The Gearhead Shader, The Eris Shader, The Tattooer Shader And The Keyhole Shader.

SHARE ITEM: